Give your Tuttio Soleil 01 dirt bike seat a fresh look and better grip with this durable replacement seat cover. Made from heavy-duty, non-slip material, it is designed to handle tough riding conditions while providing improved rider comfort and control. The stitched grip ribs help keep the rider stable during acceleration and braking.
This cover is designed to fit the Soleil 01 seat, but as with most seat covers, installation requires proper stretching and stapling to achieve a snug, professional look.
Material Options:
Less Aggressive - Has a smaller pattern in the material making it feel less rough.
Most Aggressive - Has a large deep diamond pattern that offers more grip; it is very rough to the touch.
Installation Instructions: Seat Cover for Tuttio Soleil 01
Tools Required:
Heavy-duty staple gun (with 6–8 mm staples recommended)
Flathead screwdriver or pliers (to remove old staples)
Scissors (if trimming excess material)
Installation Steps:
Remove the Old Cover (if applicable)
Flip the seat over and use pliers or a screwdriver to carefully remove the old staples.
Take off the old seat cover and clean the seat base and foam.
Position the New Cover
Place the new cover over the seat, aligning the stitch lines with the center of the seat for straightness.
Ensure the cover is evenly centered before stapling.
Staple the Front and Back First
Pull the cover tight at the front of the seat and staple it to the underside of the seat base.
Next, pull the back end of the cover tight and staple it securely.
This creates the foundation for an even fit.
Work Along the Sides
Starting from the center, pull the cover down one side and staple it, then move to the opposite side.
Continue alternating sides, pulling firmly to keep the cover tight and wrinkle-free.
Use the stitch lines as a guide to make sure the cover stays centered.
Finish and Trim
Once the cover is fully stapled, check for even tension and smoothness.
Tips for Best Results:
Pull the material firmly, but avoid overstretching to prevent tearing.
If wrinkles appear, remove a few staples and restretch that section.
Double-check that the stitch lines remain straight and centered throughout installation.
